Visit http://www.esabna.com/ for more information about our products.
1087-Plasma Station %ld Did Not Fire
| Message | Cause of Error | Correction |
| (1087) Plasma Station <N> Did not fire | Will be found only when using Smart Flow 1 & 2, with PT15, PT19 or PT600 torch. This error is generated all inputs from the plumbing box are correct, but the torch still does not fire. The CNC monitors the Arc On input from the plasma power supply to determine if the arc has transferred. If the CNC completes a firing sequence, including energizing the high freq. arc starter, but does not receive an Arc On input, then this message is generated. If this error message appears, check the following:
| 1. Check the torch consumables for wear or damage. 2. Open the spark gap cover on the High Freq. Arc Starter and observe the spark gap while firing the torch. Verify that a spark is being generated in the spark gap. Make sure that the interlock switch in the plumbing box is pulled out, in the bypass position.
|