Message

Cause of Error

Correction

(184)

No response from station <n>

Only for machines with LC-ASIOB & ASIOB stations.

No response from the station after a station-constants download (setup) to the station.

The ATHC2, 3, 4 or MB01 board must react to a download in form of either a negative or a positive confirmation. If there is no response after the period of time necessary for reaction, this message is displayed.

This error message is not displayed when the MIP simulation bit 2 (SYS.KON,5) has been set.

1. Check for Green and yellow led's on the main boards. Both should be on.

2. If yellow and green lights are not on, check power connections, (refer to schematic), voltages to connectors on the main board.

3. If green light is on and yellow is off or blinking, check communication link between main board and control.  (refer to schematics)

4. If the above tests are not conclusive, remove all the plug-in cards from the main board and re-test.  If this works then one of these cards are defective, insert one card at a time to verify which one is defective.

5. Check the DIO card, check the voltage on the connector X26 (..